Dell XPS One 2710 (Mid 2012) - Manual (Page 41)

Replacing the Memory Module(s) | 41
15 Replacing the Memory Module(s)
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Procedure
1 Align the notch on the memory module with the tab on the memory-module
connector.
2 Slide the memory module firmly into the connector at a 45-degree angle
and press the memory module down until it clicks into place.
If you do not hear the click, remove the memory module and reinstall it.
3 Slide the memory-module shield on the system-board shield and replace the
screw that secures the memory-module shield to the system-board shield.
Postrequisites
1 Replace the back cover. See "Replacing the Back Cover" on page 21.
1 tab 2 memory-module connector
3 memory module
1
3 2
OM_Book.book Page 41 Friday, April 27, 2012 3:23 PM