Dell XPS One 2710 (Mid 2012) - Manual (Page 23)

Removing the Converter Board | 23
6 Removing the Converter Board
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Prerequisites
1 Remove the back cover. See "Removing the Back Cover" on page 19.
Procedure
1 Lift the securing tab on the display-backlight cable connector and then disconnect
the display-backlight cable from the convertor board.
2 Disconnect the converter cable from the converter board.
3 Remove the screws that secure the converter board to the computer base.
4 Lift the converter board off the computer base.
1 screws (2) 2 converter cable
3 converter board 4 display-backlight cable
4
2
3
1
OM_Book.book Page 23 Friday, April 27, 2012 3:23 PM