Dell XPS One 2710 (Mid 2012) - Manual (Page 65)

Replacing the TV-Tuner Mini-Card | 65
27 Replacing the TV-Tuner Mini-Card
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Procedure
1 Align the notch on the TV-tuner mini-card with the tab on the TV-tuner
mini-card connector.
2 Insert the TV - tuner mini-card at a 45-degree angle into the TV-tuner
mini-card connector.
3 Press the outer end of the TV-tuner mini-card down and replace the screws that
secure the TV-tuner mini-card to the system board.
4 Connect the TV-in port cable to the TV-tuner mini-card.
Postrequisites
1 Replace the system-board shield. See "Replacing the System-Board Shield" on
page 33.
2 Replace the back cover. See "Replacing the Back Cover" on page 21.
OM_Book.book Page 65 Friday, April 27, 2012 3:23 PM