Dell XPS One 2710 (Mid 2012) - Manual (Page 143)

Replacing the Camera Module | 143
63 Replacing the Camera Module
WARNING: Before working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 11. After working inside your computer, follow the instructions in "After
Working Inside Your Computer" on page 13. For additional safety best practices
information, see the Regulatory Compliance Homepage at dell.com/
regulatory_compliance.
Procedure
1 Slide the camera module into the camera assembly.
2 Tighten the captive screw that secures the camera module and the grounding cable
to the camera assembly.
3 Connect the camera cable to the camera assembly and place the camera in the
computer base.
4 Replace the screws that secure the camera assembly to the computer base.
Postrequisites
1 Follow step 8 to step 19 in "Replacing the Display Panel" on page 139.
2 Replace the inner frame. See "Replacing the Inner Frame" on page 97.
3 Replace the processor heat-sink fan. See "Replacing the Processor Heat-Sink Fan"
on page 77.
4 Replace the trim cover. See "Replacing the Trim Cover" on page 89.
5 Replace the system-board shield. See "Replacing the System-Board Shield" on
page 33.
6 Replace the stand. See "Replacing the Stand" on page 49.
7 Replace the back cover. See "Replacing the Back Cover" on page 21.
OM_Book.book Page 143 Friday, April 27, 2012 3:23 PM