Dell DX6000G - Manual (Page 103)

Installing System Components 103
6 Align the front edge of the card with the two front plastic retention
standoffs next to the iDRAC6 connector on the system board, and lower
the card into place. See Figure 3-14.
When the front of the card is fully seated, the plastic standoffs snap over
the edge of the card.
Figure 3-14. Removing and Installing an iDRAC6 Enterprise Card (Optional)
7 Close the system. See "Closing the System" on page 81.
8 Reconnect the system and peripherals to their power sources, and turn
them on.
1 iDRAC6 Enterprise card 2 VFlash media slot
3 VFlash SD card 4 retention standoff posts (2)
5 retention standoff tabs (2) 6 iDRAC6 Enterprise card connector
3 2 1
4
5
6
book.book Page 103 Wednesday, December 22, 2010 2:13 PM