Removing a hard drive – Dell DX6000G User Manual
Page 83
Installing System Components
83
Removing a Hard Drive
CAUTION:
Ensure that your operating system supports hot-swap drive
installation. See the documentation supplied with the operating system.
1 If applicable, remove the front bezel. See "Removing the Front Bezel" on
2 Using the RAID management software, prepare the drive for removal.
Wait until the hard-drive indicators on the drive carrier signal that the
drive can be removed safely. See your storage controller documentation
for information about hot-swap drive removal.
If the drive has been online, the green activity/fault indicator will flash as
the drive is powered down. When the drive indicators are off, the drive is
ready for removal.
3 Press the release button and open the drive carrier release handle to
release the drive. See Figure 3-5.
4 Slide the hard drive out of the drive bay.
5 Insert a drive blank in the vacated drive bay. See "Installing a Hard-Drive
CAUTION:
To maintain proper system cooling, all empty hard-drive bays must
have drive blanks installed.
Figure 3-5. Removing and Installing a Hard Drive
1
release button
2
hard-drive carrier handle
1
2
book.book Page 83 Wednesday, December 22, 2010 2:13 PM