Dell DX6000G - Manual (Page 87)

Installing System Components 87
Figure 3-7. Removing and Installing a Power Supply
Installing a Power Supply
1 Verify that both power supplies are the same type and have the same
maximum output power.
NOTE: The maximum output power (shown in watts) is listed on the power
supply label.
2 Slide the new power supply into the chassis until the power supply is fully
seated and the release latch snaps into place. See Figure 3-7.
NOTE: If you unlatched the cable management arm in step of the previous
procedure, relatch it. For information about the cable management arm, see
the system’s rack documentation.
3 Connect the power cable to the power supply and plug the cable into a
power outlet.
CAUTION: When connecting the power cable, secure the cable with the
Velcro strap.
1 power supply 2 locking tab
3 power supply handle
1
2
3
book.book Page 87 Wednesday, December 22, 2010 2:13 PM