Dell DX6000G - Manual (Page 150)

152 Troubleshooting Your System
4 Ensure that the tape drive’s interface cable is fully connected to the tape
drive and the external port on the controller card.
5 Run the appropriate online diagnostics tests. See "Running the System
Diagnostics" on page 159.
6 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
7 Open the system. See "Opening the System" on page 80.
8 Reseat the controller card in the expansion card slot.
9 Close the system. See "Closing the System" on page 81.
10 Reconnect the system to the electrical outlet, and turn on the system,
including attached peripherals.
If the problem is not resolved, see the documentation for the tape drive for
additional troubleshooting instructions.
If you cannot resolve the problem, see "Getting Help" on page 169.
Troubleshooting a Hard Drive
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
CAUTION: This troubleshooting procedure can destroy data stored on the hard
drive. Before you proceed, back up all files on the hard drive.
1 Run the appropriate online diagnostics test. See "Using Online
Diagnostics" on page 159.
Depending on the results of the diagnostics test, proceed as needed
through the following steps.
book.book Page 152 Wednesday, December 22, 2010 2:13 PM