Dell DX6000G - Manual (Page 51)

About Your System 51
Warning!
Unsupported
memory
configuration
detected. The
memory
configuration is
not optimal. The
recommended
memory
configuration
is: <message> Invalid memory
configuration. The system
will run but with reduced
functionality.
Ensure that the memory
modules are installed in a
valid configuration.
See "General Memory
Module Installation
Guidelines" on page 111.
If the problem persists,
see "Troubleshooting System
Memory" on page 148.
Write fault
Write fault on
selected drive Faulty USB device, USB
medium, optical drive
assembly, hard drive, or hard
drive subsystem.
Replace the USB medium or
device. Ensure that the USB,
SAS backplane, or SATA
cables are properly
connected.
See "Troubleshooting a USB
Device" on page 142,
"Troubleshooting an Internal
USB Key" on page 150,
"Troubleshooting an Optical
Drive" on page 151, and
"Troubleshooting a Hard
Drive" on page 152.
NOTE: For the full name of an abbreviation or acronym used in this table, see the
Glossary
at support.dell.com/manuals.
Table 1-2. System Messages (continued)
Message Causes Corrective Actions
book.book Page 51 Wednesday, December 22, 2010 2:13 PM