Dell KVM 2321DS - Manual (Page 41)

Installation 25
USB connection, attach the SIP’s plug to the USB port on the first
server you will be connecting to this Remote Console Switch unit
(Figure 2-11).
3 To the RJ-45 connector on the SIP, attach one end of the CAT 5 cabling
that will run from your SIP to the Remote Console Switch unit
(Figure 2-11).
4 Connect the other end of the CAT 5 cable to the desired ARI port on
the back of your Remote Console Switch unit.
5 Repeat steps 2-4 for all servers you wish to attach.
NOTE: Power down the Remote Console Switch unit before servicing. Always
disconnect the power cord from the wall outlet.
NOTE: In addition to Dell SIPs, the Remote Console Switch may also be connected
to devices using IQ modules, including Sun and Serial IQ modules.