Canon 700 Series - Manual (Page 147)

Setting a Document on the Machine 5-4
5
Using the Machine as a Copier
IMPORTANT
Do not set the document guides so tight against the sides of the document, that the
document bends.
3
Make sure the documents are below the load limit marks for
A4/LTR or B4/LGL sizes.
4
Insert the documents fully into the feeder until the leading
edges of the documents stop.
The following messages appear on the LCD display:
NOTE
If the machine already displays <DOCUMENT READY> before you set your
document, a small-sized document, such as a STMT document, may have
remained in the automatic document feeder from a previous fax or copy job. In
such a case, remove the small-sized document from the automatic document
feeder, and set your document. (See Chapter 7, “Troubleshooting,” in the
Reference Guide.)