Canon 700 Series - Manual (Page 254)

Setting Up the Program One-Touch Key 10-17
Other Special F
eatures
10
An asterisk (*) indicates the default setting.
9
When you are finished setting up the program one-touch key,
press [Stop] to return to the Standby mode.
RELAY Sets the one-touch speed dialing key to substitute for the procedure of
opening all three one-touch speed dialing panels, pressing [Advanced
Communication], and selecting <RELAY TX>. Whenever you want to
use the Relay Transmission feature, press the one-touch speed dialing
key set for this feature.
POLLING Sets the one-touch speed dialing key to substitute for the procedure of
opening all three one-touch speed dialing panels, pressing [Advanced
Communication], and selecting <POLLING>. Whenever you want to
use the Polling feature, press the one-touch speed dialing key set for
this feature.
ACCESS CODE Press to use access code dialing.
SENDER’S
NAME SET You can register a sender’s name in a program one-touch key.
SET TEXT Press to enter fixed text, such as a domain name of e-mail address.
MEMORY
REFERENCE Sets the one-touch speed dialing key to function as [Memory
Reference]. Whenever you want to check or delete the documents
stored in memory, press the one-touch speed dialing key set for this
feature.
PIN CODE Sets the one-touch speed dialing key to function as [Pin Code].
Whenever you want to enter the PIN code to connect to an outside line,
press the one-touch speed dialing key set for this feature.
STAMP If you have the optional stamp feature installed, you can turn the stamp
feature ‘ON’ and ‘OFF’ without opening all three one-touch speed
dialing panels and pressing [Stamp].
ID CODE Sets a one-touch speed dialing key to function as [ID]. If you are using
Department ID Management, press the one-touch speed dialing key set
for this function when your operations are completed, or when you want
to enter a Department ID to switch the department. Otherwise, any
subsequent transmissions and copies are totaled under the
Department ID you previously entered to start operating the machine.
Setting Description
Stop