Two Brothers Racing Polaris Ranger RZR-S User Manual

V.a.l.e, Ranger rzrs 800

Advertising
background image

V.A.L.E.

V a r i a b l e a x i s l o c k i n g e x h a u s t

TM

Warranty

two brothers racing products are intended for closed course competition purposes only, and therefore are sold “as is”

without warranty. two brothers racing specifically disclaims any warranties of merchantability or fitness for a particular

purpose and disclaims all responsibility for consequential and incidental damages or any other losses arising from the use

of these products or parts.

We recommend that this performance part be installed by a qualified

motorcycle technician. If you have any doubts as to your ability to install this

performance part, please consult with your local motorcycle dealer. Read all

instructions first before starting installation. Make sure the motorcycle and

exhaust system are completely cool before starting the installation. Be sure

to save all stock components for possible use later.

**This product has not been tested with all available accessories and some

items may cause excessive heat. Excessive heat may cause damage to your

vehicle. Two Brothers Racing will not be responsible for damaged parts.

Installation Instructions

2009-10 Polaris

RangeR RZRS 800

V.A.L.E.™ Triple Full Exhaust System with M-7 Aluminum Canister
Part # 005-2750106TV

1. Make sure the quad is completely cool before starting the

installation. Make sure the quad is secure on a level surface
and the wheels are chocked to prevent the quad from rolling.

2. Remove the rear bed assembly:

- Remove the rear cage (8) bolts.
- Remove the seats.

- Remove the screws (4) behind the seats.

- Remove the screws (4) around the tail pipe.

- Remove the bolts (4) in the bed and 2 tiedown hooks.

- Remove 1 push pins and 4 screws per side.

- Unplug lights from wire harness (1) under drivers side
of bed.

- Carefully lift bed assembly off.

3. Remove OEM muffler and mid-pipe (you may need to

temporarily remove heat sheild and bed rest):
- Loosen OEM clamp.

- Remove header joint springs.
- Remove mid-pipe tension springs.

- Remove mid-pipe.
- Remove muffler assembly.

IMPORTANT - PLEASE READ CAREFULLY

Advertising