Two Brothers Racing Kawasaki Brute Force 750 EFI Dyna FS Ignition - Manual (Page 2)

Picture
1: Remove the engine covers Picture 2: Dyna FS location
Exposing the frame, coils and wiring. Located on top of tool kit
Picture 3: Crankshaft Position Sensor connection Picture 4: Front Ignition Coil and 6 Pin Connector
Located through the hood opening – below the dash Located on the right side of the frame
Calibration
The DynaFS is pre-programmed with a single performance advance curve, +4° over stock, and a 9,000 RPM rev-limit. A quicker
throttle response and increased power over the stock curve is achieved. For other advance curve information, see the CurveMaker
software. This ignition will allow the engine to rev to a higher RPM, and is adjustable to 10,000 RPM max by using the
CurveMaker software. Because the rev limit is increased, the performance limits of other engine parts (valve train, piston or
crankshaft, for example) may be found. It may be necessary to replace these parts for best engine performance. The DFS2-20 is
shipped from Dynatek with 0% adjustments to all of the fuel injection settings. For more information on fuel settings, see the
section on Using the DRSP-1 Remote Programmer.
DYNATEK 164 S. Valencia St., Glendora, CA 91741 800-928-3962 www.dynaonline.com
2801421A