To display the date when you recorded, To display the time when you recorded, When bars (—:—:—) appear – Sony CCD-TR910 User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Displaying the date or time when you recorded ■
function —CCD-TR910 only
data code
Even if you did not record the date or time when you were recording, you can display
the date or time when you recorded (Data Code) on the TV during playback or editing.
The Data Code is also displayed in the viewfinder and the display window.
To display the date when you recorded
Press DATE on the camcorder, or press DATA CODE on the Remote Commander
(CCD-TR910 only). To make the date disappear, press DATE again or DATA CODE
twice.
To display the time when you recorded
Press TIME on the camcorder, or press DATA CODE on the Remote Commander (CCD-
TR910 only) twice. To make the time disappear, press it again.
When bars (—:—:—) appear
• A blank portion of the tape is being played back.
• The tape was recorded by a camcorder without the Data Code function.
•The tape w'as recorded by a camcorder without having date ancf time set.
• The tape is unreadable due to tape damage or noise.
• The tape was recorded in LP mode.
• The tape is being played back in variable speed (Slow Playback, etc.)
• An index signal is marked, the RC time code is written, or PCM after recording is
made on the tape.
19