To change the end point, Note on re-recording – Sony CCD-TR910 User Manual
Page 41
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Re-recording a picture in the middle of a
recorded tape (CCD-TR910 only)
You can insert a scene in the middle of a recorded tape by setting the starting and
ending points. The previous recorded portion will be erased. If the RC time code
appears in the viewfinder, set COUNTER to NORMAL in the menu system to display
the tape counter.
(1) While the camcorder is in Standby mode, keep pressing the + (forward playback) or
- (reverse playback) side of EDITSEARCH, and release the button where you want
to end the insertion
[b]
. The camcorder enters Standby mode again.
(2)
Press COUNTER RESET. The counter resets to zero.
(3)
Keep pressing the - side of EDITSEARCH and release the button at the point where
you want to start the insertion
[a].
(4)
Press ZERO MEM on the Remote Commander. The ZERO MEM indicator flashes.
(5)
Press START/STOP to start recording. The recording stops automatically at the
counter zero point.
>
a.
<
a.
O
■a
To change the end point
Press ZERO MEM to erase the ZERO MEM indicator, then repeat steps 2 to 5.
Note on re-recording
The picture and the sound may be distorted at the end of the inserted portion when it is
played back.
41