Canon MR-14EX - Manual (Page 35)

FEB (Flash Exposure Bracketing)
ETTL
F b - I
■§--C.Fn MODE + §
4
Press the < sel / set > button.
► The MR-14EX’s LCD panel display
will be as shown on the left.
Focus the subject
► When you press the shutter button
halfway, the FEB setting is displayed
on the viewfinder’s right.
Take the picture.
• Check that the 4 icon is displayed in
the viewfinder before taking the picture.
Repeat steps 4 to 5 to take the
remaining two bracketed shots.
• After all three bracketed shots are
taken, the FEB setting is cancelled
automatically.
FEB cannot be used with any flash exposure compensation set with the camera.
• Before taking the picture, make sure that the MR-14EX’s pilot lamp Is lit or the
i
icon is displayed In the viewfinder. The □ (single-frame) film advance mode
Is recommended.
• In the *3||, Qy L, , or continuous shooting mode with the EOS-1 D, 1V
or EOS-3, the next bracketed picture will not be taken if the flash is not ready.
While the flash is not ready, you can still take a picture in the normal AE mode
If you release your finger from the shutter button and press It completely.
• With Type-A carheras other than the EOS-1 D, 1V and EOS-3, if the flash is not
ready, you can still take pictures In the normal AE mode.
• When the flash is ready, you can resume taking the bracketed flash shots.
“W“» FE lock and FEB can be used in combination.
• FEB and flash exposure compensation can be set together with the MR-14EX. In this
case, the FEB amount will shift according to the flash exposure compensation amount.
0
1
C.Fn-1 can prevent the FEB setting from canceling automatically after the
three bracketed flash shots are taken. (->p.64)
C.Fn-2 can change the sequence of the bracketed flash shots, (^p.64)
35