Using the wireless flash system, Focus and take the picture – Canon MR-14EX User Manual
Page 45
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using the Wireless Flash System
Using Slave C (w/EOS-1 D, 1V, 3, D30, ELAN 7/7E, or 30/33)
You can fire flash tubes A and B and slave C at the same time. A correct
flash exposure Is obtained with flash tubes A and B together, and slave C
alone is set automatically to obtain a correct exposure. Slave C is used to
eliminate background shadows or to create accent lighting.
Check that ¡nsan
a
:
b
c
¡
s
displayed on the LCD panel.
• If it is not displayed, press the <RATIO>
button until it is displayed, (^p.42)
Check that the master unit’s pilot
lamp is lit and that slave C is also
flash-ready.
Focus and take the picture.
Check that the master unit’s flash
I exposure confirmation lamp lights.
® • If the flash output of flash tube A or B or slave C Is Insufficient, the master unit's
flash exposure confirmation lamp will not light.
• If you use slave C to illuminate the subject directly, overexposure of the subject may result.
• If you set EEDEl
a
: B , slave C will not fire.
• In a wireless flash system, the master unit will always fire both flash tubes A
and B. You cannot fire only one flash tube in a wireless flash system.
With Type-A cameras, C.Fn-5 can have both the master unit and slave unit
fire together as one group. (->p.64)
• While isfinM is not displayed on the master unit, you can just position the
slave unit as desired.
45