Canon MR-14EX - Manual (Page 39)

Manual Flash Mode
Firing Both Flash Tubes at a Different Output
For step 3 on the preceding page, following the procedure below to set a
different flash output between flash tube A and B
A
M
A : B
ii\> ai:-
l3f-C.Fn MODE
L^P ^^ ^^ RATIO CH.
Press the <RATIO> button and
select
A
:
B
.
► Each time you press the button, the
selection will change in the following loop:
I—^(OFF)—► 1=^^ A : B — I
I ------^ A : B : C ◄ --------------------1
• The flash output is displayed on the
lower right of the LCD panel. When
A is displayed, the flash output
displayed is for flash tube A.
Press the < <3 > or < O > button to
select flash tube A or B, then
press the < + > or <—> button to
set the flash output.
► First select the flash tube, then set the
flash output for that flash tube.
• The remaining steps are the same as
steps 6 and 7 on the preceding page.
Firing Oniy One Flash Tube
Press the <—> button and set the flash output to -. This disables the
selected flash tube from firing.
• The -- setting comes after the 1/64 setting. The flash tube whose flash
output Is set to -- will not fire. Also, you cannot set -- for both flash tubes.
® »To prevent overheating and deteriGration of the flash tubes, observe the
following limits for continuous shooting with flash. If you reach the limit, allow
the MR-14EX to cool for at least 10 min.
(1) At 1/1 or 1/2 output: Max. 15 continuous flash shots.
(2) At 1/4 to 1/8 output: Max. 20 continuous flash shots.
(3) At 1/16,1/32, or 1/64 output: Max. 40 continuous flash shots.
I
39