Canon MR-14EX User Manual
Page 44
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting Up a Wireless Flash System
Press the master unit’s pilot lamp
(test firing button) to fire a test
flash.
► The master unit and slave unit should
fire (at 1/64 output).
• If the slave unit does not fire,
reposition it closer to the master unit
and more toward the front and center
of the master unit. Then fire a test
flash again.
Q • In a wireless flash system, the flash mode (E-TTL autoflash or manual flash),
flash ratio, flash exposure compensation, FEB, FP flash, and other settings are
all set with the master unit. The master unit transmits all these settings to the
slave unit via wireless signals.
• Before taking the picture, you can fire a modeling flash (->p.29) to check the
lighting effects.
• Test firing cannot be executed while the camera's metering is active for 6 sec.
• In the manual flash mode, the test flash will be fired at the manually-set flash
output.
44
...................................