AVer EXR5016_series user manual - Manual (Page 119)

111
- Start Recording
Record the video from the selected camera.
i
EH5108/EH5108H/EXR5008 series only has 8 channels will be available.
Beside the Start Recording check box, click Detail.
1. In the Alarm Recording Setting dialog box, select the
camera to enable/disable video recording. Enable All
to select all cameras.
2. In the Frame Rate selection, select As Setting to
record the number of frames based on the Recording
Setting.
3. In the Start Record prior text box, mark and set the
number in second for the program to begin recording
after the alarm has been trigger. The time range is
1~10 seconds.
4. In the Stop Record after text box, mark and set the
number in second for the program to continue
recording after the alarm has ended. The time range is
1~999 seconds. If user doesn ’t mark and set the time, the alarm recording will continue recording until
alarm is reset.
5. Click OK to accept the new settings and Cancel to exit without saving.
- PTZ preset point
Position the PTZ camera based on the preset point setting.
Beside the PTZ preset point check box, click Detail. In the
Trigger PTZ Preset Setting dialog box, select the PTZ camera
number then select the Enable check box. Select the position
of the PTZ camera when the alarm is activated and ended. For
the PTZ camera end point, user can also select on preset
position or Auto Pan between preset position groups.
- Send to CMS (Central Management System)
Enable/disable the selected camera to send video to CMS
when the alarm is activated. Beside the Send to CMS
check box, click Detail. In the CMS Setting, select the
camera to enable/disable sending the video to CMS.
Enable All to select all cameras. Then, click OK to accept
the new settings and Cancel to exit without saving.
i
EH5108/EH5108H/EXR5008 series only has 8 channels will be available.