AVer EXR5016_series user manual - Manual (Page 176)

168
- Start Recording
Record the video from the selected camera.
i
EH5108/EH5108H/EXR5008 series only has 8 channels will be available.
1. Beside the Start Recording check box, click Detail.
2. In the Alarm Recording Setting dialog box, select the
camera to enable/disable video recording. Enable All to
select all cameras.
3. In the Frame Rate selection, select As Setting to record
the number of frames based on the Recording Setting.
4. In the Start Record prior text box, mark and set the
number in second for the program to begin recording after
the alarm has been trigger. The time range is 1~10
seconds.
5. In the Stop Record after text box, mark and set the
number in second for the program to continue recording
after the alarm has ended. The time range is 1~999
seconds. If user doesn ’t mark and set the time, the alarm recording will continue recording until alarm
is reset.
6. Click OK to accept the new settings and Cancel to exit without saving.
- PTZ preset point
Position the PTZ camera based on the preset point setting. Beside
the PTZ preset point check box, click Detail. In the Trigger PTZ
Preset Setting dialog box, select the PTZ camera number then
select the Enable check box. Select the position of the PTZ camera
when the alarm is activated and ended. For the PTZ camera end
point, user can also select on preset position or Auto Pan between
preset position groups.
- Send to CMS (Central Management System)
i
EH5108/EH5108H/EXR5008 series only has 8 channels will be available.
Enable/disable the selected camera to send video to
CMS when the alarm is activated. Beside the Send to
CMS check box, click Detail. In the CMS Setting, select
the camera to enable/disable sending the video to CMS.
Enable All to select all cameras. Then, click OK to
accept the new settings and Cancel to exit without
saving.