AVer EXR5016_series user manual - Manual (Page 40)

32
Chapter 2 Using the DVR Software
2.1 The Way to Operate DVR
There are three ways can be managed the DVR unit:
1. Using mouse and keyboard
Connecting the mouse and keyboard through USB interface, user can manage the DVR unit easily. For the
first time using DVR unit, mouse and keyboard is the best way to set up all DVR relevant configurations.
2. Using Remote Control(Optional accessory)
After DVR unit has been setup, user can use remote control to preview, playback, backup, reset alarm,
output video and so on functions.
3. Using Front Panel button(EH5108 +
/EH5108H
+
/EH5216
+
/ EH5216H
+
/EXR5016
+
only)
It ’s an optional way to operate DVR unit. Front panel button function acts as same as remote control.
i
For the first time using DVR unit, using mouse and keyboard to setup all configurations .
2.1.1 First Time Using the DVR Unit
1. Connect the mouse and keyboard to DVR unit(through USB interface)
2. Power on the DVR unit.
3. For security purpose, the DVR system would require you to enter User ID and Password before it can be
accessed. (If this is the first time, enter the default ID [superuser] and password [111111]).
EH5216EH5216H series UI
4. The hard disk must be formatted before user can use it with DVR unit. Following the below steps to format
the hard disk.
i
- Before formatting hard disk, please stop all operations on DVR system.
- While formatting hard disk, the CPU usage will be near to 100% and might slow down the DVR
system response.
a. Click Setup and enter the password
b. Click System → Add
c. Select the hard disk from device list and select Format type
d. Click Format button to start formatting
e. When formatting is done, click OK.