AVer EXR5016_series user manual - Manual (Page 84)

76
- Enable/disable the Abnormal Event check box, to set the condition of the event for system to alarm.

Reboot: when the DVR system reboot without abnormal condition, the system will send out the
alarm message.
 Abnormal Reboot: when the DVR system reboot in irregular condition, the system will send out
the alarm message.
 Recording is switched off: when the recording has been stopped, the system will send out the
alarm message.

Network is switched off: when the network connection of DVR system is lost, the system will
send out the alarm message.
 Hard Disk failed: when the hard disk doesn
’t work normally, the system will send out the alarm
message.
- Continue trigger duration: Set a time period that when sensor has been trigger and stay in the same
status for that period, then the alarm will be sent out.
7. In (6) Alarm Reset, click the camera number to set the reset condition of alarm. Once alarm is reset, all
alarm action will stop at the moment. If the sensor normal status is high, set the alarm reset condition to low.
Click IP Camera Sensor to configure sensor status of IP camera. Click High/Low to set sensor status to
high or low.
8. In (7) Action, you may now set the alarm action for the system to perform when the alarm condition is
activated.
- Launch E-Map: Display mini E-map screen.
- Spot Monitor
When the DVR system receives the alarm, the alarm video will display on spot monitor.
Mark Spot Monitor 1/Spot Monitor 2 to enable the sport monitor function. And then, select the camera
(channel) when the DVR system receives the alarm from the selected camera will display the alarm video
on the spot monitor.