Salter Brecknell 650 - Manual (Page 23)

23
5.3 SUPER SUB MENU
Table 5-2 lists the items which are contained in the Supervisor sub-menu. The
SUPER password is 2222.
To access the Supervisor sub-menu, follow the instructions below.
1. Press the * button and scale prompts “Select a setup menu”.
2. Press the SUPER soft key. The prompts for “Input Password. Enter 2222. The
Supervisor sub-menu items are listed above the soft keys.
3. Press the soft key pertaining to the item you wish to modify. The scale shows the
current status or selection of that item in the form of a highlighted soft key text.
4. Press the soft key corresponding to the desired status then press the ENT key.
You may exit this screen without making changes by pressing the CLR key.
5. Repeat steps 3 and 4 above until the Supervisor setup is complete.
6. Press the CLR key twice to return to normal operating mode.
ITEM SOFT
KEY
DESCRIPTION
Accuracy Enable Disable ACCY Allows you to enable or disable the
controlled accuracy feature
Minimum Sample MINSPL Sets the minimum sample size value
Local Scale Filter LOCFLT Sets the amount of filtering on the TC2010
platform
Remote Scale Filter REMFLT Sets the amount of filtering on a remote
platform
TABLE 5-2: Supervisor Sub-menu Items
5.3.1 ACCURACY
1. Pressing the accuracy soft key will prompt for a password. Enter 1111. You will
then be prompted to enable or disable. If you select enable, the scale prompts for
“ Accuracy Setup” with soft keys showing percentage amounts. The higher the
selected percentage, the greater the sample weigh must be regardless of the
number of pieces. Table 5-3 illustrates the weight required in pounds for each
capacity 650 and percentage setting:
Capacity NONE 94% 95% 96% 97% 98% 99% 99.6% 99.8% 99.9%
12 lb 0 .012 .016 .024 .036 .048 .060 .072 .096 .120
30 lb 0 .030 .039 .060 .090 .120 .150 .180 .240 .300
60 lb 0 .060 .078 .120 .180 .240 .300 .360 .480 .600
120 lb 0 .120 .156 .240 .360 .480 .600 .720 .960 1.20
TABLE 5-3: Sample weight required for controlled accuracy
2. The percentage accuracy does not guarantee an accurate piece count. It controls
the performance of the scale but cannot overcome variances in part weight. It is
one half of controlled accuracy.
3. If the number of samples used does not meet the minimum weight required, the
scale will prompt for more pieces until the minimum weight is reached.