Salter Brecknell 650 - Manual (Page 9)

9
NOTE: If interfacing to a computer or remote display, see Appendix B for pin outs.
2. Configure the communication parameters and select the device type as detailed in
Section 5.4.7
NOTE 1: If using a printer with your system, be sure to set the time and date. See Sections 5.2.
Step 4. If applicable, install the remote scale.
1. Connect the remote scale to the 650’s remote scale port using the provided remote
scale cable. Consult Appendix D for proper cabling.
2. Configure the remote scale’s parameters in the Service Menu as detailed in Chapter
5.
3. Calibrate the remote scale as detailed in Chapter 6.
4. Enable the remote scale in the Supervisor Menu as detailed in Chapter 5.
Step 5. Switch the scale ON to begin use.