Salter Brecknell 650 - Manual (Page 24)

24
5.3.2 MINIMUM SAMPLE
1. Pressing the minimum sample soft key will prompt for a password. Enter 2222.
You will then be prompted to enter the minimum sample size from 1 – 100 pieces.
This setting will require the scale operator to use your selected sample size
regardless of the size or weight of the sample pieces.
2. If a scale operator uses a sample size smaller than set here, the scale will prompt
for more pieces until the minimum number of samples is reached.
3. Used in conjunction with the accuracy feature, you can be assured that all scale
operators will use the same criteria for counting.
5.3.3 LOCAL FILTER & REMOTE FILTER
1. Pressing the local filter soft key allows access to soft keys for AUTO or numeric
levels of filtering. Auto filtering lets the scale set the required level of filtering
based on existing conditions. You can also set a fixed amount of filtering with
larger numbers offering more filtering. High filtering will cause the scale to react
more slowly. If large filtering values are required due to excessive air and or
vibration, consider taking steps to eliminate the source of air movement or
vibration.
2 Pressing the remote filter soft key allows the same adjustments for an optional
remote scale platform.
5.4 SERVICE SUB-MENU
Table 5-4 lists the items which are contained in the Service sub-menu. The
SERVICE password is 3333.
To access the Service sub-menu, follow the instructions below.
1. Press the * button and scale prompts “Select a setup menu”.
2. Press the SERVICE soft key. The prompts for “Input Password. Enter 3333.
The Service sub-menu items are listed above the six soft keys. Press the Other
or Back soft keys to see more choices.
7. Press the soft key pertaining to the item you wish to modify. The scale shows the
current status or selection of that item in the form of a highlighted soft key text.
8. Press the soft key corresponding to the desired status then press the ENT key.
You may exit this screen without making changes by pressing the CLR key.
9. Repeat steps 3 and 4 above until the configuration is complete.
10. Press the CLR key twice to return to normal operating mode.