ClearSounds TALK500 ER - Manual (Page 4)

4 – ENGLISH 5 – ENGLISH
INSTALLATIoN
Installing Batteries in the phone
Your telephone requires four AA batteries (not supplied) in case of
network power failure for LCD backup & operations. When appears
on the display or the display dims, replace the batteries with new
batteries. Note: Should you choose not to install batteries - the
telephone numbers in memory and the voice recordings are stored
in non-volatile flash memory and will not be lost.
1 Before opening the battery compartment, make sure the telephone
is disconnected from the telephone line and the power supply.
2 Use a flat-blade screwdriver to lift the battery compartment door.
3 Insert 4 AA batteries into the compartment as indicated by the
polarity symbols.
4 Snap the battery compartment door back into place.
Installing Batteries in the pendant
Your pendant comes with one 12V A23 battery. When the LED on
the pendant dims, replace the battery. Using a screwdriver, open
the battery cover, insert a new battery with the correct polarity, and
replace the battery cover.
Battery Notes:
1 Replace batteries quickly to save records.
2 Use only fresh batteries of the required size and recommend type.
3 Do not mix batteries of different size or type.
4 Always remove old or weak batteries. Batteries can leak chemicals
than can damage electronic parts.
Connecting The Telephone
1 plug one end of the telephone line cord into the TEL.LINE jack at
the back of the telephone base.
2 plug the other end of the telephone line cord into the phone jack
on the wall.
3 plug one end of the coil cord into the handset’s modular jack.
4 plug the other end of the coil cord into the left side of the telephone
base.
Note: peel the plastic label from your phone’s display before using
your phone.
Talk500ER-Trilingual.indd 4 5/13/08 8:39:08 AM