ClearSounds TALK500 ER - Manual (Page 7)

6 – ENGLISH 7 – ENGLISH
Setting Flash Time
1 press and release MENU button until FLASH is shown
2 Press the DIAL button.
3 Select the desired flash time using the or and confirm by
pressing the DIAL button.
4 press the button to exit the set-up mode.
Setting Tone /Pulse Dialing Mode
You can select the required dialing type Tone/Pulse 40/60.
1 press and release the MENU button until Tone/Pulse is shown.
2 press the DIAL button.
3 Select the required dialing type using the or and confirm with
DIAL button.
4 press button to exit the set-up mode.
Setting Ringer Volume Control
The ringer sound level can be adjusted by sliding the RINGER switch
to select Hi, Mid and Lo level.
The red bright LED will flash with all incoming calls.
Setting The Handset Volume Control
The Boost LED is used to reflect the handset extra volume setting.
1 Press the RED +40dB BOOST button, the Boost LED will turn ON.
2 Increase the handset volume by turning the volume control wheel
to select the listening level (level 1 to level 9).
3 During the conversation, you may turn OFF the Boost by pressing
the RED +40dB BOOST button, the Boost LED will turn OFF and
the sound level will return to normal.
4 When you hang up, the phone will reset to normal sound level.
Note: Choose not to press the RED +40dB BOOST button and the
Boost LED will remain OFF. This is the setting to use for people who
do not require the level of amplification and tone control offered on
the phone.
Setting Tone Control (ToNE HI/Lo)
The Tone control allows you to fit your specific hearing needs, so
words are clearer and easier to understand. Slide the Tone control
DOWN to boost the lower frequency range. Slide the Tone control Up
to boost the high frequency range. Note: The tone control function
will not be effective when the Boost LED is OFF
Talk500ER-Trilingual.indd 7 5/13/08 8:39:08 AM