Oldcastle BuildingEnvelope Reliance-TC - Manual (Page 38)

ENTRANCE FRAMES
A
A
Section A-A
2 13/16"
C
L
1/4"
2 13/16"
L
C
D-186
All door framing components are shipped fabricated from the factory. The main curtain wall framing can be erected prior to
installing the doors.
C.1 Curtain wall verticals and door subframes run through to finish floor. Bed adjacent curtain wall verticals in sealant and
anchor to floor per approved shop drawings.
C.2 SUBFRAME INSTALLATION:
C.2.1 Attach TH-44 threshold clip to bottom of each subframe jamb with two (2) FS-256 #8 x 1 1/2" Phillips Round
Head Screws
C.2.2 Install WW-341 pocket filler in WW-520 vertical, WW-122 in AW-520 vertical and WW-123 pocket filler with
WW-316 isolator or WW-122 filler into horizontal. Bed fillers in sealant and cap seal fasteners at all fillers.
C.2.3 Bed subframes in sealant and anchor to curtain wall framing members with FS-325 #12-24 x 1 1/2" Drillflex at
18" on center. Seal joint between jamb and header subframes. Seal also tops of jamb subframe. SEE FIGURE 39 .
C.2.4 Bed threshold in sealant, attaching TH-44 clips with FS-42 #12 x 1/2" Phillips Flat Head screws. Marry
threshold seal with subframe and main system seal. SEE FIGURE 40, Page 39 .
C.2.5 Drill #11, .191 diameter holes in D-186 subframe for FS-15 rivets. Install door stops onto subframe with SC-1
clips @ 18" O.C. Locate clips around the subframe anchor screws. SEE FIGURE 41, Page 39. Vertical stops run through.
C.2.6 Install door per DOOR & FRAME INSTALLATION & GLAZING MANUAL
WW-316 isolator
WW-123
filler D-186
subframe
FS-325
#12-14 X 1 1/2"
Drillflex
WW-341
Subframe
anchor
Seal joint at
corner of
subframes
Subframe
anchor
Put backer rod at top of
jamb subframes; seal void
FIGURE 39
Attaching Subframes
R E L I A N C E - T C C U R T A I N W A L L I N S T A L L A T I O N M A N U A L TM
MAY 2013 38
Phone: 1-866-OLDCASTLE (653-2278)
Web Address: www.oldcastlebe.com