Rice Lake 720i Programmable Indicator/Controller - Installation Manual - Manual (Page 44)

38 720i Installation Manual
FEATURE Menu
Parameter Choices Description
Level 2 submenus
DATE DATEFMT
DATESEP Allows selection of date format and date separator character. See Level 3 submenu
parameter descriptions.
Use the TIME/DATE softkey or the SD serial command to set the date. See Section 10.0
on page 86 for information about using the serial commands.
TIME TIMEFMT
TIMESEP Allows selection of time format and separator character. See Level 3 submenu parameter
descriptions.
Use the TIME/DATE softkey or the ST serial command to set the time. See Section 10.1
on page 86 for information about using the serial commands.
DECFMT DOT
COMMA Specifies whether decimal numbers are displayed using a period (DOT) or comma as the
decimal symbol.
CONSNUM 0
0–9999999 Consecutive numbering. Allows sequential numbering for print operations. The
consecutive number value is incremented following each print operation that includes
<CN> in the ticket format. When the consecutive number is reset, it is reset to the value
specified on the CONSTUP parameter.
CONSTUP 0
0–9999999 Specifies the consecutive number start-up value used when the consecutive number is
reset by sending the KCLRCN serial command or a CLRCN digital input. Value specified
must be in the range 0–9 999 999.
TRUCK OFF
MODE1
MODE2
MODE3
MODE4
MODE5
MODE6
ADVANCE Specifies the truck mode used. If selected, the indicator switches from normal mode to
the selected truck mode. See Section 7.0 on page 58 for more information about using
the truck modes.
MODE1: Auto clear ID, keyed tares, value swapping
MODE2: Auto clear ID, no keyed tares, value swapping
MODE3: Stored ID, keyed tares, value swapping
MODE4: Stored ID, no keyed tares, value swapping
MODE5: Stored ID, keyed tares, no value swapping
MODE6: Stored ID, no keyed tares, no value swapping
ADVANCE: Enables the advance mode.
Note
Modes 1 - 6 have stored tare weight by Truck ID, Advance mode does
not have stored tare weight, only stored transactions.
ADVANCE
MODE VEHICLE
MATERIAL
CUSTOMER
SOURCE
DELIVERY
DELIVERY WGT
REMARKS
PRINT
REPRINT
SHIFTS
DAY
SERIAL NUMBER ON or OFF, default is ON
ON or OFF, default is ON
ON or OFF, default is ON
ON or OFF, default is ON
ON or OFF, default is ON
ON or OFF, default is ON
ON or OFF, default is ON
ON, OFF or PROMPT, default is ON
ON or OFF
SHIFT 1, SHIFT 2, SHIFT 3
DAY START, DAY END
Enter Serial Number (Ticket Serial Number) 0-99999999 (Default is 0)
See Table 7-2 on page 59 for more information on each prompt.
ALIBI OFF
ON Specifies whether data storage is used by the alibi feature to allow reprinting any
transaction.
Use the SOFTKEYS parameter to enable a softkey for recalling alibi print transactions.
See Section 11.12 on page 110 for more information about using the alibi feature.
Table 3-7. FEATURE Menu Parameters