Rice Lake 720i Programmable Indicator/Controller - Installation Manual - Manual (Page 45)

Configuration 39
CFGPWD 0
0–9999999
reset=999999
Configuration password. Specify a non-zero value to restrict access to all configuration
menus and PCE.
Note
If a configuration password is specified, be sure to record the password
and keep it in a safe place. If the configuration password is lost or
unavailable, the indicator must be cleared (reset configuration and
calibration parameters) to continue use.
To clear the indicator, press the setup switch, then enter 999999 (six nines) at the
configuration password prompt. The unit performs a RESETCONFIGURATION then
returns to the setup mode configuration display.
KYBDLK OFF
ON Keyboard lock. Specify ON to disable the keypad in normal mode.
ZERONLY OFF
ON Zero key only. Specify ON to disable all front panel keys except ZERO in normal mode.
SOFTKEYS None
<blank>
Time/Date
Display Tare
Display Accum
Display ROC
Alibi Softkeys provide additional operator functions for specific applications. Assignments are
listed on the tabs shown at the bottom of the LCD display; functions are activated by
pressing the arrow keys below the softkey tabs.
Setpoint
Batch Start
Batch Stop
Batch Pause
Batch Reset These features are only available with the 720i Batching version software.
Weigh
Reports
Management These features are available with the Advanced Truck Mode Only.
Weigh In
Weigh Out
Truck Regs These features are available with the Truck Modes 1-6 Only.
SKUD 1-10 User-programmable softkeys; defined by PCEE .
REGULAT NTEP
CANADA
INDUST
NONE
OIML Regulatory mode. Specifies the regulatory agency having jurisdiction over the scale site.
• OIML, NTEP, and CANADA modes allow a tare to be acquired at any weight greater
than zero. NONE allows tares to be acquired at any weight value.
• OIML, NTEP, and CANADA modes allow a tare to be cleared only if the gross weight
is at no load. NONE allows tares to be cleared at any weight value.
• NTEP and OIML modes allow a new tare to be acquired even if a tare is already
present. In CANADA mode, the previous tare must be cleared before a new tare can
be acquired.
• NONE, NTEP and CANADA modes allow the scale to be zeroed in either gross or net
mode as long as the current weight is within the specified ZRANGE. In OIML mode,
the scale must be in gross mode before it can be zeroed; pressing the ZERO key in
net mode clears the tare.
• INDUST provides a set of subparameters to allow customization of tare, clear, and
print functions in non-legal-for-trade scale installations. See Level 4 parameter
descriptions in Table 3-8 on page 41.
The value specified for this parameter affects the function of the front panel TARE and
ZERO keys. See Section 11.2 on page 101 for a complete description of TARE and ZERO
key functions for each of the regulatory modes.
REGWORD GROSS
BRUTTO Sets the term displayed when weighing in gross mode. Selecting BRUTTO replaces the
Gross annunciator with Brutto.
FEATURE Menu
Parameter Choices Description
Table 3-7. FEATURE Menu Parameters (Continued)