Rice Lake 720i Programmable Indicator/Controller - Installation Manual - Manual (Page 65)

Truck Modes 59
7.3 Weigh-In Procedure
In modes 1 and 2, the indicator erases truck ID
numbers and tare weights from memory after the
transaction. In modes 3–6, the truck ID and weigh-in
weight values are saved after the weigh-out ticket has
been processed.
The general weigh-in procedure is as follows:
1. The empty truck moves onto the scale for
weigh-in.
2. Press the Weigh In softkey.
3. A prompt is shown to enter the truck ID (up to
eight alphanumeric characters). Enter the ID,
then press the
Enter key.
4. Any additional prompts turned on in Advance
Mode will prompt the operator to enter the
required information in order to proceed to the
next step. See “Advance Mode Weigh-In
Procedure” on page 62.
5. Indicator generates the weigh-in ticket:
ID 304812
GROSS 15000. LB INBOUND
01/14/2010 10:24 AM
6. Truck leaves the scale.
7.4 Weigh-Out Procedure
The general weigh-out procedure is as follows:
1. The loaded truck moves onto the scale for
weigh-out.
2. If truck ID is known, press the Weigh Out
softkey, enter the ID, and press the Enter key.
If ID is not known, press the Truck Regs
softkey to view list of stored IDs (see
Figure 7-2 on page 58). Scroll to the correct
truck ID, note the ID number, then press the
Cancel softkey to return to the weight display.
From the weight display, press Weigh Out , key
in the ID, then press the Enter key.
3. Any additional prompts turned on in Advance
Mode will prompt the operator to enter the
required information in order to proceed to the
next step. See “Advance Mode Weigh-In
Procedure” on page 62.
4. Indicator generates the weigh-out ticket. In
modes 1 and 2, the ID is deleted once the
weigh-out ticket is processed.
7.5 Single-Transaction Tare Weights
and IDs
One-time transactions are supported in all modes that
can be configured to use stored IDs (modes 3–6). This
function allows one-time weighing of trucks without
adding the truck ID and weigh-in weight to the
permanent truck register.
To use this function, press the Weigh In or Weigh Out
softkey, then enter a truck ID containing a decimal
point. IDs entered with a decimal point as part of the ID
are erased from the truck register when the transaction
is complete.
Note
This option is not available with Advance Mode
enabled.
7.6 Using the Advance Mode
Under the TRUCK submenu ADVANCE is available.
Setting the truck mode to this enables the advance
mode. This will automatically turn on the
Weigh ,
Reports and Management softkeys.
Note
If you use Revolution III ® to enable Advanced
Mode, you also need to set the Weigh, Reports
and Management softkeys.
For a complete description for each setting of the
following choices, see “ADVANCE MODE” on
page 38 in Table 3-7.
Table 7-2. Advance Mode Features
Mode Description
VEHICLE Vehicle ID and Description
MATERIAL Material ID, Name and Description
CUSTOMER Customer ID, Name and Description
SOURCE Source ID, Name and Description
DELIVERY Delivery Number
DELIVERY WGT Weight of the material
REMARKS Additional comments
PRINT Configuration for the Weigh-In ticket.
REPRINT Configuration for reprinting the Weigh-In
and Weigh-Out tickets.
SHIFTS Configure the shift start and end times,
reports use these values.
DAY Configure day start and end times,
reports use this value.
SERIAL NUMBER
(Ticket Serial #)
0-9999999
Default is 0
Note
Advanced Truck Mode only stores
transactions in the primary units of measure.