Rice Lake 720i Programmable Indicator/Controller - Installation Manual - Manual (Page 62)

56 720i Installation Manual
6.3.2 Using the Front Panel
If you have no access to equipment for communication through a serial port or are working at a site where such
equipment cannot be used, you can use the PFORMT menu (see Figure 6-2 56) to customize the print formats.
GFMT NFMT ACCFMT
HDRFMT1 HDRFMT2 AUXFMT
TRWOUT TRFMT ALERT
Same as AUXFMT1
AUX1FMT AUX20FMT
PORT 2
PORT 4
PORT
...
PORT 2
PORT 4
PORT
SPFMT
720i
Batching Version
Software Only
FMT
SCALES SERIAL FEATURE PFORMT DIG I/O ALGOUT VERS SETPTS
720i Batching
Version only
see page 57
TRWIN
See GFMT Menu
Figure 6-2. PFORMT Menu
Each print format can be edited from the front panel using a character selection like that shown in Figure 6-3. Use
the navigation keys (
up , down , left , right ) to move around and between the format command line and the character
selection list.
GFMT
Insert ^
GFmt=> _ROSS<G><NL2><TD><NL>
<=Backspace Default Restore
*
F4 F3 F2 F1
*GROSS - G is blinking to indicate active character.
Figure 6-3. Print Formatting Character Selection Display
• To add a character: position the cursor in the format where you want to add the character. Use the up key to
return to the character selection list, use the navigation keys to highlight the character to add, then press enter .
The new character is added to the left of the current cursor location in the format string.
• To add a blank space to a string, position the cursor to the right of where the space is to be inserted in the
format string, highlight the
SP character in the selection list, and press enter .
• To delete a character, position the cursor to the right of the character to be deleted from the format string, then
press the
CLR key.