Crestron electronic Multimedia Presentation System 300 MPS-300 - Manual (Page 66)

Multimedia Presentation System 300 Crestron MPS-300
Set the Default Router The MPS-300 can be configured to use a Default Router for TCP/IP
communications. To set the IP address of the Default Router:
• Access the Network Setup menu as described on page 60.
• Press the k or j buttons until “Def. Router” is displayed on the LCD and
press ENTER to display the Default Router controls. The current IP
address of the Default Router will be displayed.
Display the Default Router Address
Def. Router
[000] 000. 000. 000
• Turn the volume control clockwise or counterclockwise to select a number.
You can also press the k or j buttons to select a number.
• Press ENTER to move the cursor to the next section of the address. To
change a different section, press the soft button under the section to be
changed.
• Repeat the previous two steps until the entire Default Router IP address is
set.
• To save the new address and return to the Network Setup menu, move the
cursor to the right-most section and press ENTER. To cancel the operation
and return to the Network Setup menu, press MENU.
Set the DHCP Mode The IP address can be obtained from a DHCP server or manually set. For
information on manually setting the IP address, refer to “Set the IP Address” on page
60. To set the DHCP mode:
• Access the Network Setup menu as described on page 60.
• Press the k or j buttons until “DHCP” is displayed on the LCD and press
ENTER to display the DHCP controls.
DHCP Settings
DHCP
*On
• Press k and j buttons to toggle between On and Off. The current setting
is indicated with an asterisk (*).
62
• Multimedia Presentation System 300: MPS-300
Operations Guide – DOC. 6529B