Crestron electronic Multimedia Presentation System 300 MPS-300 - Manual (Page 82)

Multimedia Presentation System 300 Crestron MPS-300
• Lower the volume: Turn the volume control counterclockwise. The
volume level will be displayed on the LCD.
Mute Audio The audio output of the MPS-300 can be muted with the MUTE button.
• Mute the audio output: Press the button labeled MUTE.
• Unmute the audio output: Press the MUTE button again.
Adjust Lighting To set lighting to one of two preset lighting values, press either LIGHTS PRE 1 or
LIGHTS PRE 2.
NOTE: This function will only work if a CLS-C6, infiNET switch, or infiNET
dimmer was previously identified and connected to the MPS-300. The CLS-C6 can
be identified as a Cresnet device in the MPS-300 setup screens as described on page
67. Crestron’s infiNET switches and dimmers require a C2N-MNETGW to be
identified as described on page 67 in addition to identifying the individual switch
and/or dimmer with a unique identity code (MNET ID) using Crestron Toolbox.
CLW-DIM1RF and CLW-DIMS1RF dimmers use MNET IDs 03 and 04 while
CLW-SW1RF and CLW-SWS1RF switches use MNET IDs 05 and 06. For
information on identifying infiNET switches and dimmers, refer to the Crestron
Toolbox help file.
Control from an APAD
The following describes operation of the system when using the out-of-the-box
functionality and an APAD Wall Mount LCD Controller. If a custom program has
been created, the system may function differently.
The APAD has six buttons and a Nav Wheel as shown in the following diagram.
APAD Buttons
When switching sources from the APAD, the MPS-300 will route the signal to all of
the outputs.
78
• Multimedia Presentation System 300: MPS-300
Operations Guide – DOC. 6529B