Correct start-up procedure when embroidering – SINGER 5 FUTURA QUINTET Instruction Manual User Manual

Page 82

Advertising
background image

80

Now you are prompted to select the

Program Folder where

the shortcut for the software will be stored.

Simply click on

“Next´ to continue.

)LQDOO\\RXDUHUHTXHVWHGWRFRQ¿UPDOOWKHVHOHFWLRQVPDGH
during the installation set-up.

Pressing the

"Next" button will finally start the copy and

installation of the software ¿les to the given directory on the
hard disk.

A

progress bar will indicate the stage at which the installation

SURFHGXUHLV,WZLOO¿QLVKZKHQLWKDVUHDFKHGWR100%.

7KHLQVWDOODWLRQSURFHGXUHLV¿QDOL]LQJDOOUHTXLUHGDFWLRQVDQG
will automatically close after finish. Please wait for a short
while until this happens.

If the installation utility identifies

a lack of available space

on your hard disk, an error message will prompt you to free
some hard disk space before proceeding with the installation.
You can always abort the installation procedure by clicking on
“Cancel´.

CORRECT START-UP PROCEDURE
WHEN EMBROIDERING

The following steps must be followed for proper start-up
protocol. If these steps are not followed precisely, you will
get a “Transmission Pending” error message.

Boot up your computer, but do not open the embroidery
software. Next attach the embroidery unit to your sewing
machine and connect the USB cable between your
computer and sewing machine.

1. Turn on your sewing machine. Make sure the needle has

been moved to the highest position by turning the Hand
wheel towards you.

2. Attach the hoop that you plan to work with to your

embroidery unit.

3. Double click on the

FUTURA

icon on your desktop to

open up the embroidery software.

4. You are now ready to select and transmit a design to

your machine.

Advertising
This manual is related to the following products: