Wine Guardian Ducted Wine Cellar Cooling Systems (WG175) - Manual - Manual (Page 35)

31
Mounting the Unit
CAUTION
警示
RISK OF PERSONAL INJURY OR DAMAGE TO EQUIPMENT
造成人身伤害或设备损坏危险
Check supporting structure for load bearing capacity to support the Wine Guardian.
All supports must be designed to meet applicable local codes and ordinances.
If in doubt, consult a qualified architect, engineer or contractor.
检查负载支撑结构的承载能力是否可以支持酒卫主机。
所有支持的设计必须符合地方法规和条例。
如有疑问，请咨询合格的建筑师，工程师或承包商。
Note: Review the mounting illustrations on pages 32 and 33 before mounting the unit.
注意：回顾前 32 页，33 页上机组安装插图。
Floor Mounting
Mount the Wine Guardian on the floor but elevate it on frame with a plywood surface to
keep it away from water. Allow adequate space for the external drain.
地板安装
如果酒卫主机安装在地板上，请使用框架，上面加胶合板， 保持离水。允许足够的排水管空
间。
Wall Mounting
If the unit is mounted through the wall, adequately support it on both sides of the wall. Use
floor or knee braces to transfer the load of the unit to the floor or wall.
壁挂式安装
如果主机是穿墙 安装，墙的两边都要有充分的支撑。使用地板或三角支撑，把主机的重量转
移到地面或墙上。
Ceiling Mounting
Construct a structurally sound, level platform to place the unit on when hanging it from the
ceiling joists. The Wine Guardian is NOT designed to be suspended from the top of the unit.
Place the unit on a platform to ensure that the unit is supported on all for corners. Leave ad-
equate space on the top of the unit to remove the access doors for service.
In all cases the unit must be level to within +/- 6mm end-to-end and +/- 3mm side-to-side for
proper operation. Locate the unit as close to the wine cellar as possible to reduce the length
of the duct runs. If possible, use short and straight ducting on all ductwork. The addition of
6mm thick rubber pads helps prevent the transmission of vibration and noise.