Wine Guardian Ducted Wine Cellar Cooling Systems (WG175) - Manual - Manual (Page 42)

38
Installation of the Wine Guardian Remote Sensor
安装酒卫遥控传感器
The Remote Sensor is a combination temperature and humidity sensor
only. It is designed to be mounted within the wine cellar and can be used
in combination with the Remote Interface Controller or up to three
additional Remote Sensors to read and control multiple areas within the
wine cellar.
遥控传感器是温度和 湿度传感器合为一体。它必须安装在酒窖内，
与遥控控制器接口。 一个遥控控制器接口最多只能连接三个额外的
遥控传感器。
Mounting the remote sensor 安装遥控传感器
Disconnect the communication cable from the side of the Wine
Guardian unit and the remote sensor. Install the communication
cable within the wall and/or ceiling structure of the wine cellar
to the desired controller mounting location. 断开酒卫侧面的
通信电缆和遥控传感器，将通信电缆安装在酒窖的墙内或
天花板结构内，并接到理想的安装位置
Important
注意事项
A splitter device has been supplied within the Remote Sensor kit. The splitter device
must be mounted at the WG unit as shown. DO NOT mount the splitter device at the
back of the Remote Interface Controller or to the back of the Remote Sensor as this
WILL cause component or system damage.
在遥控传感器套件包里面包括一个分离器插
口。分离器插口的安装必须安图 1 所示，装在主机上 。不要把分离器插口安装在遥控
控制器接口板背面或遥感器的背面，因为这会导致部件的损坏或系统损坏。
Fig.1
Fig. 1