Wine Guardian Ducted Wine Cellar Cooling Systems (WG175) - Manual - Manual (Page 64)

60
.
检查是否有任何不寻常的噪音或震动或摩擦，如很大的噪音声响。
Initially, the unit may run continuously for several hours, up to a day or more, while it lowers the
cellar temperature. Once the unit reaches the set point temperature, it shuts off and starts to cycle
on and off as it continues to lower the bottle temperature to the set point. The cellar air reaches
set point before the bottles. If the cellar temperature started at 24°C, the supply air temperature
discharged from the unit will probably be 8°C to 11°C colder. As the cellar temperature decrease
to 13°C, the supply temperature differential decreases 6 to 7°C colder.
机器第一次运行，设备可能连续运行几个小时，到一天以内，让酒窖温度降低。一旦设
备达到设定温度，它会关闭，并开始循环启动和关闭，直至 达到酒瓶设定温度。温度设
定点应先达酒窖温度点， 后达酒瓶设定温度点。如果酒窖温度开始在 24℃，机器排出送
风温度可能是 8 ° C 至 11 ° C 左右。当酒窖里的温度下降到 13℃，供应温差可能减小在 6
至 7 ° C 之间。
Cycling the Unit 机器循环
The fans continue to free-wheel for several minutes when the unit cycles off. This is normal.
If the unit is furnished with a low ambient control, the condenser fan also cycles on and off
during cooling. This maintains the head pressure on the compressor under low ambient
conditions, and is normal. The bottom of the compressor stays warm even when the unit is off to
keep the lubricating oil warm and separated from the refrigerant.
机器关闭以后，风扇继续转动几分钟，这是正常的。
如果本机配有一个低温环境控制选项，冷凝器风扇在制冷过程中也会循环开和关。由此保
持低温环境条件下对压缩机头压力，是正常的。压缩机的底部保持温暖，即使是关闭的机
器，保持润滑油温暖，保证制冷剂不分离。
Setting the Thermostat 设置温控器
Normal settings are between 12 and 14°C. If the optional heating coil is furnished, enter a
separate temperature setting to maintain the lower setting. To prevent the unit from short cycling,
the setting between heating and cooling cannot be closer than 2°C.
正常设置是 12 至 14 ° C。如果主机配有加热选项，请输入一个分开的温度设定，这可以
维持较低的设置。的加热线圈的设定在一个分开的温度设定，这可以维持较低的设置。为
了避免机器短循环，加热和冷却温度差的设置不能小于 2 ° C。
Regulating the Wine Cellar Temperature 酒窖温度调节
Wine cellars have a natural temperature gradient of approximately 3°C between floor and
ceiling. To increase or decrease the temperature in various zones, change the air flow patterns.
To keep the entire wine cellar at the same temperature, set the thermostat to run the supply fan
continuously and not just when the cooling is operating. Set Fan switch to ON instead of AUTO.