Garmin GPS 65 - Manual (Page 28)

want(e.g,, to get the letter “G”, press the "3" key and then Uie left
arrow).
Enter the coordinates for the "GARMIN” waypoint using the Mnift
method described for setting the present position (see Swtion 3.3).
Note, however, that depending on the unit setups, Lat/Lon
coordinates will be entered in one (degrees only), two (degrees/
minutes) or three (degrees/minutes/seconds) fields. These setups
are covered later in Chapter 6. Refer to tiie table below for the
proper location numbers to enter;
Setup Latitude Longitude
D^^rees Oidy
D^rees/Minutes
D^^ees/Min/Sec
N38.94992“
N38“ 56.995’
N38“ 56* 59.r
W94.74638*
W94“ 44.782*
W94“44’46.9“
With the coordinates entered, you are ready to proceed with the
GOTO function.
Enter 'GARMIN' with
atpbanumeric um I arrow keys.
t
*PUuNAVi^ait^ifmKded
GOTOGARMIN,„
• Press GOTO/MOB. The GOTO
Page is displayed with the cursor
tmder the C5OT0 waypoint name.
• Enter the waypoint name,
‘GARMIN” with the alphanumeric
keys and the arrow keys. Press
ENT.
- A navigation page is then
displayed.
• If the Navigation Summary Page
is not shown, select it with the
NAV softkey.
GO TO GflRMIN
»R« lB0>Kiio 12.2
» T R K Í 0 0 k G $ 0 , 0
1.0
PúíHIF'LOT!
1.1
M f l U
3-14