Garmin GPS 65 - Manual (Page 51)

last fi^uency and bit rate which you selected (or Uie default frequency
of 304.0 kHz and bit rate of 100 bps if no previous beacon has been
tuned). You may enter your own frequency (between 283.5 kHz and
325.0 kHz in 0.5 kHz increments) and bit rate if you desire. Amessage
of "Tuning” will then be displayed near the bottom of the page, directly
after the “SNR” field. If the “Tuned To:" firequency cannot be received
within the timeout period, the unitwill stop tryii^ to tune, the “Tuned
To:” field will display all blanks, and a status message of“No Status” will
display after the “SNR” (signal>to*noise) field. You must provide the
unit with another frequen<y and bit rate before it will attempt to tune
s^ain. The last field on the Beacon Receiver Setup Page is the “View
Beacon confirmation field. Pressii^ “ENT” on this field will
display the Beao>n Page.
Freq Stn ID Dist
Й" eeei ^.8!
n
.. —ГЛ
n
__ _m
n
_. _m
Freff OLR to cancel
The Beacon Log Page displays the last
five frequencies tuned by the user, or
the default frequency if no user
frrequencies have been tuned. The most
recently tuned firequency is at the top of
the list. If the tuned firequency station
identifier and position were available
when the frequency was last tuned, the
list will also display the "Stn ID” number
and the distance to the transmitting beacnn. You can tune any
firequency in this list by pressing the left or right arrow key until the
desired frequency is hi^lighted and then press “ENT”. The display wilt
immediately return to the Beacon Receiver Setup Page with the selected
frequency from the Beacon Log Page as the “Tuned To:” firequency, and
the bit rate as the lastbit rate used with the selected firecpiency. If you
view the Beacon Log Page and decide that you do not want to tune any
of the frequencies in the log, simply press ^LR” on any field to return
to the Beacon Receiver Setup Page.
e.10 SllNRlSE/SUNSET PLANNING
SUNRISE / SUNSET
WPT= GRRMIH
Date: 10-DEC-32
Ris« 87:26:22
S«t 16:56:58
The Sunrise/SunsetPage allows you
to calculate the sunrise and sunset
times for a given waypoint location
on a selected date (from 1990
throi]^ 2089).
6-9