Garmin GPS 65 - Manual (Page 42)

Enter the bearii^ and distance from the existing waypoint to the
new waypoint.
Egress ENT. Alatitude and loi^tude location for the new waypoint
should now be displayed.
5.4 WAYPOINT SCANNING
Throughout this manual, each time we have encountered a waypoint
name field, we have entered the waypoint name with the alphanumeric
keys. An alternative is to use the wa}rpomt scanning feature.
To Scan for a Waypoint.»
GO TQ:|
-Tppe woppoint nome te
change destination .
-Press tlOi to reset man
overboard position.
-Press ENT to activate
GO TO navigation.
As an example, use the GOTO
waypoint field. Press GOTO.
The waypoint name field is
highlighted and may be blank or
may already show a GOTO
destination.
Ifthewaypointname
field is not blank, press CLR.
• Press WPT, A waypoint name is now displayed.
• Scan for the desired waypoint with the arrow keys. (NOTE; As
you are scanning, up to nine neEirest waypoints will be shown first;
followed by the entire list in numeric and alphabetical order.)
To limit the scaiming range, you may specify the first letter(s) or
number(s) of the waypoint name.
To Perform a Limited Scan.»
HPT:
N
W .
►REF:_________
SRQ:__ * RNG:_____
___ LIST PROM NRST HPT
For this example, select the
Waypoint Definition Pi^e with
WPT and the WPT softkey, if
needed.
Highlight the waypoint name field
with the arrow keys.
If this field is not blank, press
CLR.
Enter the first character of the waypoint name. For this example,
enter the letter “G”,
Press WPT, Use the arrow keys to scan through all waypoints that
begin with the letter “G”.
5-3