Garmin GPS 65 User Manual
Page 64
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
• Connect the positive side of the alarm or relay to the positive side
of tile 5^0 volt DC power source.
The GPS 65 may be connected to other marine electronics such as an
autopilot or plotter which use an NMEA 0180, NMEA 0182 or NMEA
0183 data interface. The unit can provide data for up to three NMEA
'listeners’* simultaneously. Refer to installation instructions of these
devices for further information.
To connect the GPS 65 to an NMEA electronic device...
• Connect the BLUE harness lead to the NMEA “A” line of a two-
wire, shielded cable.
• Connect the BLACK harness lead to the NMEA “B" line of the
shielded cable.
• Connect the BLACK harness lead to the shield of the shielded
cable. (The opposite end of the shield should not be grounded.)
To connect the GPS 65 to an electronic device supplyii^ RTCM
SC-104 data...
- Connect the WHITE harness lead to the output pin of the RTCM
device.
- Connect the BLACK harness lead to the groimd pin of the RTCM
device
• If the GARMIN Beacon Receiver is used, the Beacon Receiver
page(BeeSection6,9)willtunethebeaconfrequen<y.
Connectthe
BROWN harness lead to the input pin (RS-232 RXD) of the
GARMIN Beacon Receiver.
Refer to the GARMIN Beacon Receiver Operating Manual for connection
instructions.
C-4