To change the pre-defined datum, 9 beacon receiver setup, User-defined – Garmin GPS 65 User Manual

Page 50: Shr_dp tuning view beucon log

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

To change the pre-defined datum*.

• H^hlight the ^‘Change?* field and press ENT.

• With the arrow keys, find the desired datum and highlight it.

• Press ENT. The new datum is selected

nftP PATUn

►User-defined

dM

0^ dv

4Z

0F

t

dfl

e . e e * ;

dF e.eeeeee0ee-04

0*V

The user-defined datum option allows
you to custom-tailor a datum reference

fixim which all position coordinates are
calculated. All entries are defined as
differences finm the WGS 84 standard
datum. CAUTION; Selection and use of
the user datum fimction is for individuals

experienced in the use of map datums.

If the pre-defined map datums do not

correspond to the chart you are using and you are unsure of the correct

entries required to correspond to that chart, contact the chart

manufacturer. Incorrect entries for a user-defined datum may result in

substantial position errors.

6.9

BEACON RECEIVER SETUP

P E A C O N A E O E IU E R

Tuned To: 304. 0k№
Bit Rote ^100

bps

tistunce _____________ m

SHR_dP Tuning

View Beucon Log?

F-FiEti HUM

ne

;:

t

The Beacon Receiver Setup Page allows
you to control a GARMIN Beacon
Receiver for Differential GPS (DGPS)
position corrections. Before the beacon
receiver can be controlled by the GPS
65, it must be connected to the I/O port
on the back of the unit and the "RTCM/
NMEA 0183” mode must be selected on
the Interface Setup Page. If this

interface mode is not selected, the GPS 65 will only display the message
*No RTCM/NMEA 0183 interface selected* on the Beacon Receiver

Setup Page. Once the correct interface is chosen, the Beacon Receiver
Setup Page will display as shown above.

The "Tuned To;” field is the frequency in kHz to which the beacon
receiver is currently tuned or is attempting to tune. Below this field is

a bit rate cyclic field which allows you to choose between bit rates of 25,
50,100, and200bps by pressing the *‘CLR”key which the "BitRate” field

is hi^di^ted. AVhen you first select the Beacon Receiver Setup Page
fi*om the Auxiliary Menu, (after selecting an RTCM/NMEA 0183 input/
output interface mode), the GPS 65 wiU automatically try to tune the

6-8

Advertising