Y-cam Bullet HD 1080 (1st Gen) - Manual (Page 12)

Page 12
3.1 Hardware installation
3.11 Using standard supplied cable
Secure the Network Camera to the wall/ceiling by the supplied camera stand.
If the housing was opened for microSD card installation or factory default, please re-install the parts in the following
order (A to E) and make sure you tightly fasten the screws
Please Note: To ensure water-proof function, put the waterproof rubber in place (see the figure), before installing the
back cover. There is one additional unopened desiccant (silica gel) inside the housing. To prevent condensation on the
lens, please replace the desiccant bag with a new one, when re-assembling the camera. An unopened bag can last 3
months but the durability might be shortened under severe environments.