Y-cam Bullet HD 1080 (1st Gen) - Manual (Page 13)

Page 13
3.12 Using Cable connect
1) Loose the back cover by removing the 3 screws on the back cover
2) Disconnect the Ethernet, power and terminal block wires on the supplied cable from the main board
3) Remove the supplied cable from the back cover by loosening the plastic connector at the back.
4) Disassemble the supplied ½” conduit gland included
5) Pull the network and power cable through the flex conduit (not included)
6) Thread through the outside part of the conduit gland with the flex conduit
7) Attach the inner part of the conduit gland to the back cover
8) Pull the network and power cable through the back cover of the camera
9) Connect the flex conduit to the back cover and tighten the conduit gland
10) Plug the network and power cable into the camera’s internal Ethernet and power connector
11) Replace the desiccant with new one supplied.
12) Re-attach back cover
13) Secure the Network Camera to the wall/ceiling by the supplied camera stand
1
2