Y-cam Bullet HD 1080 (1st Gen) - Manual (Page 37)

Page 37
The Mobile stream is similar to the first two streams but is purely for mobile viewing and has a fixed resolution.
Stream Setting Options
[Image size] Three image resolutions are available: 1920 x 1080 for primary stream, 1280 x 720 or 640 x 360 for
secondary stream, 320 x 180 or 160 x 90 for mobile stream.
[Encode Type] You can select different video compression format in H.264 or MJPG
[Frame rate] The frame rate can be adjusted in the range 1-30. The frame rate is automatically determined by the camera
and this depends on the network bandwidth available at the time. This frame rate setting imposes the maximum frame
rate that the camera will transmit.
[H.264 bit rate] 1 Kbps ~ 8 Mbps – Increase Bit Rate to increase the picture quality; or vice versa. H igher bitrates require
greater bandwidth. Please select the appropriate settings according to your connection speed and network traffic. If you
are experiencing jerky video it may be necessary to decrease the bitrate. For the Mobile Stream, the bitrates are listed a
lot lower but retain the same principle.
[MJPEG Quality] This sets the quality of the video when viewing the camera using Motion JPEG (without audio). It can
be from 1 to 51 where 51 is the best quality.
6.3.4 Hardware
6.3.4.1 GPIO
[GPIO] This is used to configure normal circuit status for receiving and triggering Alarms.
[GPIN 1] Normal Status: sets “Open” or “Close” for the Normal Status of GPIN circuit.
[GPOUT 1] Normal Status: sets “Open” or “Close” for the Normal Status of GPOUT circuit
Once you have edited the settings you need, click “SAVE SETTING” to save the settings.