BendixKing AV8OR Ace - Users Guide - Manual (Page 291)

Honeywell Bendix/King AV8OR Ace User’s Guide
D200904000003 Automotive Mode Operation
Rev 3 Mar 2012 Page 3-33
© Honeywell International Inc. Do not copy without express permission of Honeywell
Symbol Type Description
Section
control These speed cameras work in pairs, and do
not measure your current speed but your
average speed between the two speed
cameras. Both identify your car and record
the exact time you pass them. They use the
difference between the two points in time to
calculate your average speed.
GoDrive
warns you when you approach one of these
speed cameras, but as you pass by, the
warning stays on, and your average speed
is measured until you reach another speed
camera of this type. If your average speed
exceeds the speed limit between the two
speed cameras, you receive the same
special warning sound as with the other
speed camera types. In the rare case
GoDrive cannot register the moment you
pass the second speed camera (for
example, it is placed at the exit of a tunnel
where GPS position is not yet available) the
warning continues. Just tap the speed
camera symbol displayed on the screen to
stop the warning.
Red light These cameras check if you obey traffic
lights. The warning is similar to mobile
speed cameras: as there is no speed limit
given, only the proximity is announced.
CAMERA DIRECTIONS
A speed camera can measure the speed of one direction of the
traffic, both directions, or even several directions in an intersection,
when they are mounted on a rotating base. The same directions
apply to red light cameras.
GoDrive warns you only if you drive in a
measured or possibly measured direction. The measured direction of
the camera appears with the following symbols:
Symbol Description