BendixKing AV8OR Ace - Users Guide - Manual (Page 414)

Honeywell Bendix/King AV8OR Ace User’s Guide
Appendix D200904000003
Page 6-20
Rev 3 Mar 2012
© Honeywell International Inc. Do not copy without express permission of Honeywell
CONNECTION TO AN EXTERNAL TRAFFIC SOURCE
Zaon XRX - Serial Setup
CONFIGURATION OF THE ZAON XRX
To configure the Zaon XRX, perform the following steps:
•
Using the XRX AIRCRAFT menu, set the aircraft type as
appropriate for your aircraft as described in the ZAON users
Manual.
•
Using the XRX RANGE menu, set the horizontal detection range
to 6 nm radius.
•
Using the XRX ALTITUDE menu, set the altitude limitation to
2500 ft.
•
Using the XRX COM menu, set the third party communications
to PROFILE 1.
o Verify the XRX configuration switches are set as
described in the XRX Users Guide for third-party output.
•
Press Mute to return to the traffic screen. This screen will show
“PROFILE 1”.
•
Set the configuration switches on the Zaon XRX to the correct
configuration to use the RS-232 output.
CONFIGURATION OF AV8OR
To configure the AV8OR ACE to receive external traffic data,
perform the following steps:
•
If the Weather Source is set to “COM 1” or “COM 2” , it
must be changed to Bluetooth or a different COM port than
is used by the ZAON or None .
•
From the Aviation Main Menu, tap the soft key to
open the System Setup Menu.
•
Highlight the Device Setup option and tap the SELECT soft
key to show the Device Setup page.
•
The AV8OR ACE must be set up so that the Traffic Port is
configured as “
COM 1” or “COM 2” . The Type must be set
as “ ZAON Traffic” .
•
On the Device Setup page, the configuration steps are: